Aniomagic - examples - intermediate kit 3


Be inspired! Check out other examples, or let us know how we can help.




Lights to switch Secure the brass beads on both lights with the same thread. Make several passes through each bead for good connections.


Fasten the switch and cut the thread here.

You must cut your conductive thread before proceeding.

Switch to battery holder (plus) Connect the other end of the switch to the round tab on the battery holder. Again, cut your thread.


Battery holder to lights (minus) Connect the square tab on the battery holder to the two silver beads. It may be close, but make sure this new segment of thread does not touch the first one.


Finally, insert the battery and carefully seal the holder shut.